Results for pocketwizard ms1 electronic flash cable
A 16 inch straight cable to connect PocketWizard to Sunpak flash units, allowing these flashguns to be triggered remotely and wirelessly from the camera via the Pocket Wizard radio trigger system.
Click For Info
The Pocket Wizard MP3 Electronic Flash Cable is a 3 foot cable to connect PocketWizard to Balcar, Bowens, Whitelighting, Hensel, Photogenic, Calumet, Norman and Profoto studio flash.
Click For Info
The Pocket Wizard MH3 Electronic Flash Cable is a 3 inch cable to connect PocketWizard to Comet, Norman, Speedo, Dynalite, Novatron, Lumidyne, Quantum Q-flash and Sunpak 120J, 555, 622.
Click For Info
The Pocket Wizard MA1 Electronic Flash Cable 16 inch straight connecting cable for PocketWizard devices to Elinchrom studio flash heads.
Click For Info
The Pocket Wizard MP1 Electronic Flash Cable is a 16 inch straight cable designed to connect PocketWizard to studio flash heads with a 1/4 inch phono connection such as Bowens.
Click For Info
The Pocket Wizard MV1 Electronic Flash Cable is a 16 inch Straight cable to connect PocketWizard to Vivitar flash units.
Click For Info
The Pocket Wizard MM1 Electronic Flash Cable is a 16 inch miniphone right angle to miniphone straight cable to connect PocketWizard to Elinchrom MicroCompact, Broncolor, Alein Bees, Visatec, etc. It can also be used for Bronica 6x6 & 645 motor drive connection and Hasselblad motor grip motor drives.
Click For Info
The Pocket Wizard MH1 Electronic Flash Cable is for remotely triggering a flash equipped with a household sync terminal. The cable is 12 inches long and connects from Household Male Terminal to 1/8\" (3.5 mm) Mono Miniphone.
Click For Info
The Pocket Wizard ME1-6P Electronic Flash Cable is a 16 inch cable for connecting PocketWizard to Metz 45CL1, 45CT/CL-3/4 and 60CT-4 flashguns.
Click For Info
Illuminate your scene with the powerful FL-900R Electronic Flash from Olympus which boasts outstanding IPX1-rated weather resistance and a guide number of 190\' at ISO 100 and the 100mm setting....
Click For Info
The Plantronics Savi Office APS-10 Electronic Hookswitch Cable for Siemens / Funkwerk communicates electronically with the phone, eliminating the need for a HL10 lifter. Enables One Touch Remote Call/Answer with Plantronics Savi Office Wireless Headset Systems. See www.plantronics.com for full...
Click For Info
The Plantronics Savi Office APA-20 Electronic Hookswitch Cable for Alcatel communicates electronically with the phone, eliminating the need for a HL10 lifter. Enables One Touch Remote Call/Answer with Plantronics Savi Office Wireless Headset Systems. See www.plantronics.com for full compatibility...
Click For Info
The Plantronics Savi Office APC-40 Electronic Hookswitch Cable for Cisco communicates electronically with the phone, eliminating the need for a HL10 lifter. Enables One Touch Remote Call/Answer with Plantronics Savi Office Wireless Headset Systems. See www.plantronics.com for full compatibility...
Click For Info
The Plantronics Savi Office APP-50 Electronic Hookswitch Cable for Polycom communicates electronically with the phone, eliminating the need for a HL10 lifter. Enables One Touch Remote Call/Answer with Plantronics Savi Office Wireless Headset Systems. See www.plantronics.com for full compatibility...
Click For Info
The Plantronics Savi Office APT-30 Electronic Hookswitch Cable for Avaya GmBh (Tenovis) communicates electronically with the phone, eliminating the need for a HL10 lifter. Enables One Touch Remote Call/Answer with Plantronics Savi Office Wireless Headset Systems. See www.plantronics.com for full...
Click For Info
Jack Sockets 3.5mm - BKL 1108003, Plastic cable mounting stereo jack socket from BKL. BKL Electronic 1108003 Cable Mounting Stereo Jack Socket 3.5mm
Click For Info
This Pocket Wizard MS1 Connection Cable is a 12\" long cable that features a Miniphone plug at one end to connect to the receiver, and a Sunpak 1-pin plug at the other end, for use with Sunpak flash units that have a 1-pin connection (e.g. 383 or 544).
Click For Info
The Pocket Wizard PC5N Camera Sync Cable is a 5 foot coiled lead with a PC Male attachment and a 1/8\" (3.5 mm) Mono Miniphone. It is compatible with most camera or flash PC terminals, including locking ring-equipped models.
Click For Info
The Pocket Wizard Canon T3 Pre-Trigger MotorDrive Cable is a 3 foot cable designed to connect a PocketWizard device to a Canon camera that utilises the T3 type remote release connection eg Canon EOS1N.
Click For Info
The shoe-mounted flash is in clean, undamaged condition, including the battery compartment. The flash has been seen to operate, but requires two AA-type batteries (not included) for operation. The flash has both shoe operation contacts and a synchronization release cable which is stored in a recess...
Click For Info
The extension flash bracket cable FL-CB05 allows the use of the Olympus external flash units in connection with Olympus digital camera models equipped with a hot shoe. It has a maximum length of 1 metre and can be connected via clip-on hot shoe to the compatible Olympus digital camera. With this...
Click For Info
Professional flash connecting cable with spiral coil for pull relief. Signal red, length approx. 10 m (33 ft.) PC plug and jack plug ø 6.35 mmThe cable\'s bright colour is surprisingly useful in the prevention of nasty trips in the studio!
Click For Info
This electronic hook switch cable is designed for remote desk phone call control (answer/end).
Click For Info
This cable enables the connection of Nikon hot shoe flashguns to Phottix Indra battery packs, reducing flash recharge delay and increasing charge longevity.
Click For Info
This cable enables the connection of Sony hot shoe flashguns to Phottix Indra battery packs, reducing flash recharge delay and increasing charge longevity.
Click For Info
This cable enables the connection of the Phottix Mitros flashgun to Phottix Indra battery packs, reducing flash recharge delay and increasing charge longevity.
Click For Info
This cable enables the connection of Canon hot shoe flashguns to Phottix Indra battery packs, reducing flash recharge delay and increasing charge longevity.
Click For Info
A 2m straight extension cable for use with the Elinchrom Quadra heads. Multiple cables can be daisy chained togetherhowever the use of extension cables can reduce the performance - for best results use the 2.5m cable included in single head and kit confgurations or the alternative single lengths...
Click For Info
This 1.5 metre cable is for connecting the Elinchrom Quadra heads to the battery pack. It is a shorter spare/replacement for the cable supplied as standard with the heads.
Click For Info
This 5 metre cable is for connecting the Elinchrom Quadra heads to the battery pack. It is a longer spare/replacement for the cable supplied as standard with the heads.
Click For Info
This 2.5 metre cable is for connecting the Elinchrom Quadra heads to the battery pack. It is a direct spare/replacement for the cable supplied as standard with the heads.
Click For Info
This 10 metre cable is for connecting the Elinchrom Quadra heads to the battery pack. It is a longer spare/replacement for the cable supplied as standard with the heads.
Click For Info
This 3.5 metre cable is for connecting the Elinchrom Quadra heads to the battery pack. It is a longer spare/replacement for the cable supplied as standard with the heads.
Click For Info
A 1m straight extension cable for use with the Elinchrom Quadra heads. Multiple cables can be daisy chained togetherhowever the use of extension cables can reduce the performance - for best results use the 2.5m cable included in single head and kit confgurations or the alternative single lengths...
Click For Info
The Pocket Wizard MP3 Electronic Flash Cable is a 3 foot cable to connect PocketWizard to Balcar, Bowens, Whitelighting, Hensel, Photogenic, Calumet, Norman and Profoto studio flash.
Click For Info
The PocketWizard CM-N3-ACC Remote Cable is for remotely triggering the electronic shutter release of Canon cameras equipped with a N3 Remote Terminal. It is required for remote camera triggering with a FlexTT5 trigger if using E-TTL functions. In addition, the PocketWizard CM-N3-ACC cable contains...
Click For Info
The Pocket Wizard N-MCDC2 Electronic Remote Cable is designed to connect a PocketWizard MultiMax with ACC port or TT5 trigger device to a Nikon camera supporting the MD-DC2 type remote release connection and Pre-Trigger switch eg the D90 or D5000. This cable incorporates the Pre-Release circuitry...
Click For Info
The Pocket Wizard N-MCDC2-ACC Electronic Remote Cable is designed to connect a PocketWizard MultiMax with ACC port or TT5 trigger to a Nikon DSLR supporting the MD-DC2 type remote release connection eg the D90 or D5000. It should be noted however that battery consumption will increase. MSMM stereo...
Click For Info
The PocketWizard NM4-ACC Remote Cable is for remotely triggering the electronic shutter release of Nikon DSLR\'s cameras equipped with a 4 pin Remote Terminal (except D70). It is required for remote camera triggering with a MultiMax with ACC port or FlexTT5 trigger (not PlusII), if using TTL...
Click For Info
